Xerox 4110 User Manual page 388

11 . P r ob l e m S ol v i n g
Symptoms
Images on the
copy are
skewed.
Part of the image
is missing on the
copy.
A stripe pattern
appears in
copies.
11 - 1 0
Check
Is the document loaded
correctly?
Is paper loaded properly in
the tray?
Is the paper guide for paper
tray 5 (manual feed) set so
that the tray touches the
paper?
Is the document guides at
the correct position?
Is the paper tray set
properly?
Is the paper damp?
Is the loaded paper folded
or wrinkled?
Is the document pasted
together or folded in?
Is too large a document
enlargement ratio set?
Remedy
Load the document correctly.
Refer to "Step 1 Load Documents" on
page 2-1.
Load paper correctly.
Refer to "Load paper in Trays 1 and 2" on
page 7-4.
Load paper correctly.
Refer to "Load paper in Tray 5 (Bypass)"
on page 7-6.
Load the document correctly, and align the
document guides with the edge of the
document.
Refer to "Step 1 Load Documents" on
page 2-1.
Firmly push in the tray as far as possible to
set it properly.
Refer to "Load paper in Trays 1 and 2" on
page 7-4.
If the paper is damp, either some parts of
the copy are not shown or the copy is
smudged and unclear. Replace with paper
from a new ream.
Refer to "Load paper in the trays" on
page 7-4.
Remove the defective paper and replace
with paper from a new ream.
Refer to "Load paper in the trays" on
page 7-4.
A probable cause is that the pasted or
folded in section is curling back, and has
risen up from the surface of the document
glass. Place a stack of white sheets on the
document to hold the document down flat
against the document glass.
Stripes sometimes appear in copies at
some enlargement ratios. Adjust the copy
enlargement ratio.
Refer to "Reduce/Enlarge" on page 2-15.
X er o x 4 5 90 / 4110 C op i e r /P r i n te r U s er G ui d e