Emptying Punch Scrap Container - Xerox 4110 User Manual

Emptying Punch Scrap Container

X er o x 4 5 90 / 4110 C o pi e r /P r i n te r U s er G u i de
The Control Panel screen will display a message indicating when
it is time to empty the punch scrap container. Once you discard
the scraps according to the message, the machine resets the
punch counter to 0.
NOTE: If you pull the container out to check the level and place
the container back into the machine without emptying it, the punch
counter is still reset to 0 and the actual punch count no longer
reflects the correct amount of scraps in the container.
To ensure that the container does not overflow and result in jams
in the Finisher, it is recommended that you regularly check and
empty the punch scrap container, such as every time you open the
Finisher door.
KEY POINT: Remove the container while the power is on. If you
switch off the power when emptying the scrap container, the
machine will not be able to detect that the scraps have been
disposed. Ensure that all scraps are discarded.
Make sure that the machine has stopped, and then open the
1.
right cover on the finisher.
Pull out the punch scrap container.
2.
1 0. M a i nt en a nc e
10-17