Load Paper In Tray 8 (Post-Process Inserter) - Xerox 4110 User Manual

Load paper in Tray 8 (Post-Process Inserter)

X er o x 4 5 90 / 4110 C o pi e r /P r i n te r U s er G u i de
CAUTION: For paper heavier than 256 gsm, slide both Paper
Weight Switches to the heavier weight position (257 - 300 gsm).
Failure to do so may result in paper jams.
Move both Paper Weight Switches to their appropriate
5.
positions.
6. Push the tray in gently until it comes to a stop.
NOTE: When the loaded tray is closed, the tray position is
automatically adjusted in the front/back direction based on the
paper size.
Following describes the procedure for loading paper in the
Post-Process Inserter.
The Post-Process Inserter is meant for loading paper (blank,
copied paper, and so forth) to be used as separators and covers.
Media loaded here will not be used to make copies.
NOTE: When adding paper to the Post-Process Inserter, remove
any paper remaining in the tray, add it to the stack of paper to be
added, then load all of the paper into the
Post-Process Inserter at once.
Hold the center of the paper guides and slide them to the
1.
desired paper size.
7. P a pe r an d O t he r M e di a
7-9