[Network] Menu; [Digital Link Mode]; [Digital Link Status] - Panasonic PT-VMZ40 Operating Instructions Manual

[NETWORK] menu

On the menu screen, select [NETWORK] from the main menu, and select an item from the submenu.
Refer to "Navigating through the menu" (x page 59) for the operation of the menu screen.
f To use the wireless LAN function with the projector, it is necessary to attach the optional Wireless Module
(Model No.: AJ-WM50).

[DIGITAL LINK MODE]

(Not available for PT-VMZ40)
Switch the communication method of the <DIGITAL LINK/LAN> terminal of the projector.
1) Press as to select [DIGITAL LINK MODE].
2) Press qw to switch the item.
f The items will switch each time you press the button.
[AUTO]
[DIGITAL LINK]
[LONG REACH]
[ETHERNET]
Possible communication modes
l: Communication possible
―: Communication not possible
Setting
[AUTO]
[DIGITAL LINK]
[LONG REACH]
[ETHERNET]
*1 Communication via a twisted-pair-cable transmitter is not available. Connect the projector to the network directly.
Note
f The maximum transmission distance between the twisted-pair-cable transmitter and the projector is 100 m (328'1") for the signal with
resolution of 1 920 x 1 200 dots or less. For the signal with the resolution exceeding 1 920 x 1 200 dots, the maximum transmission distance
will be 50 m (164'1").
f The maximum transmission distance when connected with the long-reach communication method is 150 m (492'2"). In this case, the signal
that the projector can receive is only up to 1080/60p (1 920 x 1 080 dots, dot clock frequency 148.5 MHz).
f When the communication method of the twist-pair-cable transmitter is set to long reach, the projector will connect with long-reach
communication method when [DIGITAL LINK MODE] is set to [AUTO]. To connect with the optional DIGITAL LINK Switcher (Model No.: ET-
YFB200G) with the long-reach communication method, set [DIGITAL LINK MODE] to [LONG REACH].
f Connection will not be made correctly if the twist-pair-cable transmitter does not support the long-reach communication method even if
[DIGITAL LINK MODE] is set to [LONG REACH].

[DIGITAL LINK STATUS]

(Not available for PT-VMZ40)
Display the DIGITAL LINK connection environment.
1) Press as to select [DIGITAL LINK STATUS].
2) Press the <ENTER> button.
f The [DIGITAL LINK STATUS] screen is displayed.
[LINK STATUS]
Chapter 4 Settings - [NETWORK] menu
Switches the communication method automatically to DIGITAL LINK, long reach or Ethernet.
Fixes the communication method to DIGITAL LINK.
Fixes the communication method to long reach.
Fixes the communication method to Ethernet.
(100 m (328'1"))
For DIGITAL LINK
For long reach
For Ethernet
The content of display is as follows.
[DIGITAL LINK]: Communicating in the DIGITAL LINK method.
[LONG REACH]: Communicating in the long reach method.
[ETHERNET]: Communicating in the Ethernet method.
[NO LINK]: Communication is not established.
Communication possibility
Image transfer Image transfer
(150 m (492'2"))
l
―
―
l
―
―
Ethernet
―
l
l l
―
*1
l
―
l
l l
―
*1
l
ENGLISH - 95
RS-232C
l
l
―
l
l
―