Table of Contents
Advertisement
Preparing
the
remote
control
For video equipment connection
Inserting the batteries
cover off.
(2) Insert the two
supplied batteries
(size AA/R6).
Ensure that the
polarities (+ and —)
of the batteries are
aligned correctly.
Lens cap (attached to the lens of the unit) [1]
About the lens cap
The lens cap is fixed on the bottom of the
unit as shown in the illustration below.
A
'@) Slide the cover
|
back until it
snaps into place.
Notes
+ If the remote control gets wet, wipe it dry immediately.
e Avoid excessive heat and humidity.
* If you will not be using the remote control for a long time. remove the
batteries.
+ Do not mix new and old or different types of batteries.
+ There are operations that can only be carried out by remote control.
Handle the remote control carefully.
Remote control effective range
Cc
How to use the carrying case
The remote sensors are located on the front and back of the unit.
Packing the unit
The controllable range is 50 degrees horizontally and 30 degrees
vertically relative to a line that is at a right angle to the remote
sensor. And the distance between the point of the remote control
and remote sensor must be shorter than four meters (13 feet).
Operating
R
Instructions
Rene
"wun PT-D7
Advertisement
Table of Contents
