About The Application; Mode; Wireless Printing - Intermec 730 User Manual

Chapter 4 — Network Support

About the Application

100
Bluetooth is not started automatically by default after a cold-boot is per-
formed. To run Bluetooth, tap Start > Settings > the Connections tab >
the Bluetooth icon. The 700 Color Computer retains the Bluetooth state
when warm-boots are performed, for example:
S If Bluetooth is active, and a warm-boot was performed, the 700 Color
Computer boots up with the Bluetooth state activated and Bluetooth
virtual COM ports (such as printing) registered. However, you must
reactivate connections, as the system does not do these automatically.
S If Bluetooth is inactive, and a warm-boot was performed, the 700 Color
Computer boots up with Bluetooth deactivated.

Mode

The default tab activates or deactivates Bluetooth. When Bluetooth is acti-
vated, the 700 Color Computer discovers and connects to remote devices.
700 Color Screen

Wireless Printing

Use this tab to print via Bluetooth devices. Tap Device Discovery to dis-
cover (or scan) for remote Bluetooth devices. When the 700 Color Com-
puter is finished scanning, any newly discovered devices appear in the up-
per Devices box.
Tap Clear Devices to remove the list from the Devices box.
To print to a Bluetooth device, select any of the devices listed in the
Devices box, then tap Connect. Once connected, the selected device
moves to the lower Connected box.
To view connection information or register a COM port for a device,
from the lower Connected box, select a device, then tap Properties. See
"Properties" on the next page for information.
When done printing to a device, select that device in the Connected box,
then tap Disconnect. This moves the device in question back to the upper
Devices box.
730 Screen
700 Series Color Mobile Computer User's Manual