Using Reader Commands; Change Configuration - Intermec 730 User Manual

Appendix A — Configurable Settings

Using Reader Commands

Change Configuration

254
After the 700 Color Computer is connected to your network, you can
send the 700 Color Computer a reader command from an application to
perform a task, such as changing the time and date. Some reader com-
mands temporarily override the configuration settings and some change
the configuration settings.
The Change Configuration command must precede any configuration
command. If you enter a valid string, the 700 Color Computer configura-
tion is modified and the computer emits a high beep. To send the Change
Configuration command through the network, use the
syntax where command is the two-letter command syntax for the configu-
ration command followed by the value to be set for that command.
You can also make changes to several different commands by using the
$+ [command]...[command n]
command settings that can be changed in this way. See each command for
information on respective acceptable "data" values.
Command
Audio Volume
Automatic Shutoff
Backlight Timeout
Key Clicks
Virtual Wedge Grid
Virtual Wedge Postamble
Virtual Wedge Preamble
Example 1
To change the Beep Volume to Off, you can send this string to the 700
Color Computer through the network:
where:
$+
Indicates Change Configuration.
BV
Specifies the Audio Volume parameter.
0
Specifies a value of Off.
Example 2
To change the Beep Volume to Very Quiet and the Virtual Wedge Grid
to 123:
$+BV1AF123
where:
$+
Indicates Change Configuration
BV1
Specifies Audio Volume, set to Very Quiet (1)
AF123
Specifies Virtual Wedge Grid, set to a value of 123.
syntax. There are seven configuration
Syntax
BVdata
EZdata
DFdata
KCdata
AFdata
AEdata
ADdata
$+BV0
700 Series Color Mobile Computer User's Manual
$+ [command]