Fujitsu ETERNUS DX80 S2 User Manual page 151

Appendix A Event Notification Message List
A.2 Message List
Sense code
SK ASC
04 F8
06 11
06 C1
06 C1
06 C1
06 E2
06 F2
06 F2
06 F2
06 F2
06 F2
06 F2
06 F2
06 F2
06 F2
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
ASCQ
00 The pinned data occurs.
90 Writing of Bad Data (data lost identifier) occurs.
01 CM is rebooted.
10 CA is rebooted.
90 IOM is rebooted.
92 Disconnection of a REC path between cabinets is detected.
80 Rebuild has started.
80 Redundant copy is being performed.
81 Rebuild to the drive has started.
82 Rebuild to the hot spare is complete.
82 Redundant copy is complete.
83 Rebuild to the drive is complete.
84 Copyback is being performed.
85 Copyback is complete.
88 Rebuild to the hot spare or the replaced drive is complete,
but Bad Data (data lost identifier) exists.
Copyright 2013 FUJITSU LIMITED
Description
151
Remarks
This sense code is notified when "Pinned
data" is enabled for Error Severity Level
in the event notification setting.
This is not notified during maintenance
operations.
This sense code is notified when "Bad
data" is enabled for Error Severity Level
in the event notification setting.
This is not notified during maintenance
operations.
These messages are notified when
"Remote Path Error" is enabled for
Warning Level in the event notification
setting.
They are not notified during
maintenance operations.
This sense code is notified when
"Remote Path Error" is enabled for Error
Severity Level in the event notification
setting.
This is not notified during maintenance
operations.
This sense code is notified when
"Rebuild/Copyback w/o redundant" is
enabled for Error Severity Level in the
event notification setting.
This is not notified during maintenance
operations.
This sense code is notified when
"Redundant" is enabled for Error Severity
Level in the event notification setting.
This is not notified during maintenance
operations.
These sense codes are notified when
"Rebuild/Copyback w/ redundant" is
enabled for Error Severity Level in the
event notification setting.
They are not notified during
maintenance operations.
This sense code is notified when
"Complete Redundant Copy" is enabled
for Error Severity Level in the event
notification setting.
This is not notified during maintenance
operations.
These sense codes are notified when
"Rebuild/Copyback w/ redundant" is
enabled for Error Severity Level in the
event notification setting.
They are not notified during
maintenance operations.
These sense codes are notified when
"Complete rebuild" is enabled for Error
Severity Level in the event notification
setting.
They are not notified during
maintenance operations.
P3AM-4842-12ENZ0