Changing Transmitter Frequency Setting; Remote Operation - Casablanca La FLeur Owner's Manual

Fan Control
To start the fan, press the appropriate speed button to run the fan at the desired
speed.
• = Low speed •• = Medium speed ••• = High speed
To turn off the fan, press the FAN OFF button.
Airflow Direction
To reverse the airflow, press the REVERSE button. REVERSE operates at any speed,
whether the fan is on or off. The fan returns to its set speed after reversing.
Light Control
Turn the light on or off independently from the fan by pressing the LIGHT button. If
you press the button for more than 0.7 seconds, it becomes a dimmer. The light varies
from "bright" to "dim" over approximately 8 seconds. If you continue to hold the LIGHT
button, this sequence will reverse when the light reaches the brightest or dimmest level.
Release the button when the desired level is reached.

CHANGING TRANSMITTER FREQUENCY SETTING

Note: All fans leave the factory set to "0000."
You will only have to change the dip switch settings in the remote
if you are using more than one fan in the same area and want to
control them separately.
Step 1. At the circuit breaker or fuse box, turn the power off for
the fan you want to change.
Step 2. Open the battery door of the Prime•Touch control and
remove the batteries.
Step 3. Change the dip switch settings, assuring that they are
different from the previously installed Prime•Touch fan.
Step 4. Re-install the batteries and the battery door on the control.
Step 5. At the circuit breaker or fuse box, turn the power back
on for the fan whose frequency you are changing.
Step 6. Within 20 seconds of restoring power, push the HIGH,
MED, and LOW buttons (in that order).
Note: You may want to label your controls to assure you
do not mix them up.
If the fan is not functioning after installation:
Step 1. Check to make sure that batteries are installed correctly
in the control.
Step 2. Turn the power off to the fan (from the circuit breaker)
for at least 5 seconds.
Step 3. Turn the power back on (at the circuit breaker) and push
the HIGH, MED, and LOW buttons–in that order–within 20
seconds.
Step 4. The fan should now function properly.

REMOTE OPERATION

L F
a Leur
Send Signal
LED
HIGH
MED
LOW
LIGHT
Dip Switch
Set to "1000"
WARNING!
Do not turn the power off at the circuit breaker, then
back on, for the previously installed Prime•Touch2
fan(s), as you may inadvertently change the
frequency settings for it as well.
HigH 3
med 2
low 1
Press in this order to set new
Circuit Breaker
or Fuse Box
1. HIGH
™
REvERSE
FAN
OFF
Dip Switch
Set to "0101"
frequency:
2. MED 3. LOW
11