Fan Preparation; Blade Installation - Casablanca La FLeur Owner's Manual

BLADE INSTALLATION

BLADE HARDWARE (not to scale)
Blade Iron
Reversible Blade (total of 5)
Medallion Front Medallion Back
Screw A for attaching
Screw B for attaching Screw C for attaching
Medallion Front and Back Medallion to Blade Blade Iron to Motor
to Blade (4 per blade) Iron (2 per blade) Housing (2 per blade iron) Phillips Screwdriver Allen Wrench
Screw A
Step 4a. In order to install the blades, remove the five shipping
blocks attached to the rotating motor plate using the provided
screwdriver. Save these screws for use in Step 4d.
Step 4b. Attach a two-piece blade medallion to each blade
by sandwiching the narrower end of a blade between a
medallion front and medallion back, threading the medallion
screws through the matching holes in the three pieces, and
tightening the medallion screws securely using the provided
screwdriver. (Note: The medallion front should be attached
to the side of the blade you want facing downward from the
ceiling.) Repeat for each blade assembly.
Step 4c. Attach a blade iron to each blade by threading two
Screw C
B screws through the blade iron and blade badge screw holes,
then tightening the screws securely using the provided Allen
Screw B
wrench.
Step 4d. Attach each blade/blade iron assembly to the upper
edge of the motor by threading two C screws through the
matching holes in the blade iron and the motor, then tightening
the screws securely using the provided screwdriver.
REMINDER: Five of the 10 C screws needed for this step
were removed from the shipping blocks in Step 4a.
Shipping Block
6