Fan Installation Getting Started; Crossbar Mounting Bracket Installation - Casablanca La FLeur Owner's Manual

Installing a New Ceiling Fixture Outlet Box
If you do not have an existing fixture located where you wish
to place your Casablanca fan, an approved ceiling fixture
outlet box must be installed and wired.
WARNINg: To reduce the risk of fire, electrical
shock, or personal injury, mount to outlet box marked
"Acceptable Fan Support of 22 kg (50 lbs.) or less"
using the mounting hardware provided with the
outlet box.

CROSSBAR MOUNTING BRACKET INSTALLATION

CEILING HARDWARE (not to scale)
Crossbar Mounting Bracket
NOTE: After removing the old fixture, check the outlet box
to ensure it is supported by a joist or beam across its upper
surface. If not, a 2 x 4 stud must be installed.
Step 1a. Remove the knockout plug in the center of the
outlet box or drill a -inch hole for the lag screw to pass
1
/
2
through. Then drill a -inch guide hole into the joist or
1
/
4
beam to a depth of 3 inches.
Step 1b. Route the outlet box wires through the keyhole
slot of the crossbar mounting bracket. Attach the crossbar
mounting bracket to outlet box with the screws provided,
ensuring that the outlet box wires are not pinched by the
washer.
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with the
approved outlet box to install the crossbar mounting
bracket.
WARNINg!
Support directly to building structure only.
4
FAN INSTALLATION
GETTING STARTED
Using Existing Ceiling Fixture Outlet Box
After turning the power OFF at its source (either the circuit
breaker or fuse box), lower the old fixture and disconnect the
wiring. Check the ceiling fixture outlet box to be sure that
it is marked "Approved For Ceiling Fan Mounting." If it is
not, a new box must be installed.
NOTE: The weight of this fan is 33 pounds.
Wire Nut (4)
Lag Screw / " #7 x 5" (1)
3
8
Ceiling-Fan-Approved
Wiring Box
Crossbar Mounting
Bracket
Green Ground Wire
APPROVED
OUTLET BOX
HARDWARE
ADDITIONAL HARDWARE
"
2 1 /4 x 8-32 Rounded Head Screw (2)
"
1 x 8-32 Rounded
Head Screw (2)
Large Flat Washer
Joist
Flat Washer (2)
"
/ (1)
3
8
Ceiling
Wiring
Ridge side down