Solving Printer Problems - Lexmark MS719 User Manual

Troubleshooting
Unsupported option in slot [x] [55]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the unsupported option card from the printer controller board, and then replace it with a supported card.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
USB port [x] disabled [56]
Try one or more of the following:
•
From the printer control panel, select Continue to clear the message and continue printing.
The printer discards any data received through the specified serial port.
•
Select Reset active bin to reset the active bin for a linked set of bins.
•
Make sure the USB Buffer menu is enabled.

Solving printer problems

•
"Basic printer problems" on page 201
•
"Hardware and internal option problems" on page 204
• "Paper feed problems" on page 208
Basic printer problems
The printer is not responding
Action
Step 1
Make sure the printer is turned on.
Is the printer turned on?
Step 2
Check if the printer is in Sleep mode or Hibernate mode.
Is the printer in Sleep mode or Hibernate mode?
Step 3
Check if one end of the power cord is plugged into the printer and the
other to a properly grounded electrical outlet.
Is the power cord plugged into the printer and a properly grounded
electrical outlet?
Yes No
Go to step 2. Turn on the printer.
Press the Sleep button Go to step 3.
to wake the printer
from Sleep mode or
Hibernate mode.
Go to step 4. Plug one end of the
power cord into the
printer and the other to
a properly grounded
electrical outlet.
201