Some Held Jobs Were Not Restored; Supply Needed To Complete Job - Lexmark MS719 User Manual

Troubleshooting
•
Make sure the Serial Buffer menu is set to Enabled.

Some held jobs were not restored

From the printer control panel, select Continue to clear the message and continue printing.
Note: Held jobs that are not restored remain in the printer hard disk and are inaccessible.
Standard network software error [54]
Try one or more of the following:
•
From the printer control panel, press
•
Unplug the router, wait for 30 seconds, and then plug it back again.
•
Turn off the printer, and then turn it back on.
• Update the network firmware in the printer or the print server. For more information, visit the Lexmark support
Web site at http://support.lexmark.com.
Standard USB port disabled [56]
Try one or more of the following:
•
From the printer control panel, press
Note: The printer discards any data received through the USB port.
•
From the printer control panel, set USB Buffer to Auto.

Supply needed to complete job

Try one or more of the following:
•
From the printer control panel, select Prompt for supplies to view all error messages that indicate what supplies
are needed to continue processing the current job, and then press
1
Order the missing supply immediately.
2
Install the supply. For more information, see the instruction sheet that came with the supply.
• Cancel the print job, then install the missing supply, and then resend the print job.
Too many bins attached [58]
1
Turn off the printer.
2
Unplug the power cord from the electrical outlet.
3
Remove the extra bins.
4
Connect the power cord to a properly grounded electrical outlet.
5
Turn the printer back on.
to confirm.
to clear the message and continue printing.
to clear the message and continue printing.
199