Oce 3165 Operator's Manual page 90

MATERIAL SAFETY DATA SHEET
(93/112/EEC and ISO 11014-1)
Océ F11 Toner
9. Physical and chemical properties
Explosion limits (dust explosion) LEL 60
Appearance and odour
Boiling point (
Vapour density (air = 1)
Solubility in water
Vapour pressure
Other characteristics
10. Stability and reactivity
Thermal decomposition
Hazardous decomposition products
Hazardous reaction
Combustion products
11. Toxicological information
Inhalation
Skin
Eyes
Ingestion
Mutagenicity
12. Ecological information
This product is not biodegradable.
The ingredients are not classified as ecologically hazardous. No adverse environmental effects are expected.
13. Disposal considerations
Pack waste dustproof to prevent dusting. With due observance of local laws and regulations, dispose of by burial in a sanitary landfill or
incineration. Do not throw in open fire, in order to prevent the risk of a dust explosion.
14. Transport information
This product is not classified as a dangerous substance according to the international transport regulations.
15. Regulatory information
This product is not classified as a dangerous preparation according to the European Directives 67/548/EEC and 88/379/EEC for the
classification, packaging and labelling of dangerous substances and preparations.
Therefore, indications of special risks or safety advice on the packing are not prescribed for this product.
16. Other information
Use: ink powder for copiers.
Room ventilation: see operator manual or safety data sheet for the copier.
©1997 Océ-Technologies B.V.
The content of this safety data sheet is subject to the disclaimer of liability on
page 84 of this manual.
90 Océ 3165 Key Operator Manual
g/m 3
. UEL U (= unknown)
Black powder, faint odour
o
C) N.A
N.A.
Insoluble
N.A.
N.A.
* At high concentration in air the powder may cause discomfort of upper respiratory system.
* No adverse health effects are expected.
* Dust may cause discomfort in the same manner as nuisance dust.
* Considered relatively harmless.
No mutagenicity detected in Ames test.
* These statements are based on toxicological literature on the ingredients of this product and test results of similar
products.
Number E-212-a-UK
Date September 1997
Page 2 of 2
o
Flash point ( C)
o
Ignition temperature ( C)
3
Bulk density (kg/m )
o
Softening point ( C)
Evaporation rate (butyl acetate = 1)
% Volatile
pH (solution)
o
Above approx. 450 C
None at intended use
None
Carbon dioxide, carbon monoxide, water
N.A. (=Not Applicable)
U
ca 1000
Approx. 50
N.A.
0
N.A.