4.5 Installing the Leg Actuator to the Base
1.
Perform the following to secure the leg actuator to the mast
bracket:
a.
Position leg actuator A into the mast bracket B.
Move the legs C to align the holes in the leg actuator with
b.
the holes in the mast bracket.
Install the pin D through the holes of the leg actuator and
c.
mast bracket and secure with hitch pins E.
Connect the leg actuator cable F to the bottom of the control
2.
box G.
3.
Ensure the actuator plug is fully pushed into the control box.
4.
Check the service light. Refer to 4.7 Checking the Service Light,
page 18.
1171892-A
4.6 Installing the Shifter Handle
This procedure applies to the ILIFTHM and ILIFTEM only.
Remove the shifter handle A from the packaging carton.
1.
Line-up the shifter handle threads B with threaded opening C
2.
in the base.
3.
Turn the shifter handle clockwise and securely tighten into the
base.
Assembly
17