Mounting The Battery Charger; Charging The Battery - Invacare ILIFTEE User Manual

I-Lift™

5.6 Mounting the Battery Charger

Refer to your local regulations concerning proper mounting
procedures.
Place the battery charger with mounting bracket A on the wall
1.
at the desired position.
2. With a pencil, mark the middle hole B position.
3. Measure down 6½ inches from the pencil mark and drill one
mounting hole.
Install the bottom mounting screw C until there is an
4.
approximate 1/8-inch gap between the screw head and the wall.
5. Install the battery charger with mounting bracket onto the
bottom mounting screw.
6. Drill the remaining two mounting holes.
7. Install the two remaining mounting screws D through the
mounting bracket and into the wall. Tighten securely.
8. Plug the battery charger into the wall electrical outlet.
ON LED should illuminate.
24

5.7 Charging the Battery

Invacare recommends the battery be recharged daily to
prolong battery life.
An audible alarm will sound (horn will beep) when battery
is low.
Lift up on the handle A on the back of the battery B.
1.
Lift the battery up and out away from the control box C.
2.
CAUTION!
Mounting the battery improperly may cause injury or
damage.
– Make sure there is an audible click when mounting
battery on the battery charger to confirm proper
mounting.
3. Place the battery on the battery charger D as shown. Make sure
there is an audible click.
1171892-A