Sling's; Unpacking And Preparation; Installing The Charging Station - Invacare Robin User Manual

1.4 Sling's

Use only CE-marked sling's with a rated load equal to or lower than that of the Robin's max load.
The sling must be suitable for 2 or 4 point spreader bars (please look at Invacare's brochure concerning slings),
i.e. with sewn lifting loops that can be mounted onto a 2 or 4 point spreader bars.
1.5 Unpacking and preparation
Perform a visual inspection of Robin . If the packaging is damaged upon arrival, Robin parts must be
TM TM
thoroughly examined for visible damage or defects. If there is any suspicion of damage, Robin must not be used
TM
before qualified service personnel or service technicians have approved the hoist.
It is to be expected, that the hoist´s battery is discharged on account of self-discharge. The hoist must therefore
be charged for up to 2 hours before first time usage, refer to section »Charging«.
The following is to be included in the package:
1. Robin .
TM
2. Hand control.
3. Quick guide. (The charging unit must be ordered separately; part no.: 1446317).
1.6 Installing the charging station
The charging unit should be attached to the wall, or the most practical place, within reach of a socket outlet, to
park the hoist when not in use. It is important to make sure that the hand control can be readily placed into the
charger holder when being charged. Therefore place the charger at a maximum distance of 85 cm under the rail in
which the hoist is mounted.
It is important to make sure that there is access to the mains where the charger is placed.
To mount the charger:, first insert wall fitting with 2 screws, then connect the cable from the charger to the
actual holder, and press the holder onto the mounted wall support.
The wall support for the charger must be mounted with three screws under the holder and at a distance that suits
the length of the charger cable.
Connect the charger to the socket outlet and check that it is operational.
More than one charging unit can be mounted for one hoist, as these can work independently.
Be aware that only an IP67 charger can be mounted in a wetroom, See section 8.2
9