6
6.5
Specifying software switch settings (machine
functions)
By specifying the software switch settings ("Mode Selection", "Bit Selection"
and "Hex Selection"), various machine functions can be changed to meet
your specific needs.
Reminder
Do not change any modes or bits other than those described in this
manual.
Note
When "Enhance Security" is set to "ON", the software switch Settings
cannot be changed.
Software SW settings
Parameter
Mode Selection
Bit Selection
HEX Selection
6-22
Description
The parameter to be specified is expressed as a three-digit
number. Use the keypad to type in the value.
The bits are the eight numbers that construct the mode sta-
tus. By specifying a binary number (0 or 1) for each of the bits
(0 through 7), a setting for each parameter can be specified.
Specify a setting for each mode as a hexadecimal number (0
through 9 and A through F). Bit setting "0011 0000" is ex-
pressed as the hexadecimal setting "30".
Specify a mode setting by using either bits or hexadecimal
values.
Control Panel Settings
VarioLink 2221/2821/3621