Specifying Software Switch Settings (Machine Functions); Software Sw Settings - Oce VarioLink 2221 User Manual

Specifying management settings
8.3 Specifying software switch settings (machine
functions)
By specifying the software switch settings ("Mode Selection", "Bit Selection"
and "Hex Selection"), various machine functions can be changed to meet
your specific needs.
Reminder
Do not change any modes or bits other than those described in this
manual.
Note
When "Enhance Security" is set to "ON", the software switch settings
cannot be changed.

Software SW settings

Parameter
Mode Selection
Bit Selection
HEX Selection
VarioLink 2221/2821/3621
Description
The parameter to be specified is expressed as a three-digit
number. Use the keypad to type in the value.
The bits are the eight numbers that construct the mode
status. By specifying a binary number (0 or 1) for each of
the bits (0 through 7), a setting for each parameter can be
specified.
Specify a setting for each mode as a hexadecimal number
(0 through 9 and A through F). Bit setting "0011 0000" is
expressed as the hexadecimal setting "30".
Specify a mode setting by using either bits or hexadecimal
values.
8
8-11