Front Brake Hose Installation - Yamaha YZ250(R)/LC Owner's Service Manual

FRONT BRAKE AND REAR BRAKE
3. Install:
9 Spring 1
9 Brake pedal 2
9 O-ring 3
9 Bolt (brake pedal) 4
9 Clip 5
NOTE:
9 Apply the lithium soap base grease on the
bolt, O-ring and brake pedal bracket.
9 Install the clip with its stopper portion a fac-
ing inward.
4. Install:
9 Pin 1
9 Plain washer 2
9 Cotter pin 3
NOTE:
After installing, check the brake pedal height.
Refer to "REAR BRAKE ADJUSTMENT" section
in the CHAPTER 3.
EC5A5911
Front brake hose
1. Install:
9 Brake hose 1
To brake hose holder 2.
NOTE:
Before tightening the bolt (brake hose holder),
align the top a of the brake hose neck with the
brake hose holder bottom b. Then pass the
brake hose in front of the axle boss c and fit it
into the hose groove d so that the brake hose
does not contact the nut (wheel axle).
2. Install:
9 Hose cover 1
9 Plain washer 2
9 Bolt [hose cover (M8)] 3
9 Bolt [hose cover (M6)] 4
5-22
CHAS
26 Nm (2.6 m•kg, 19 ft•lb)
10 Nm (1.0 m•kg, 7.2 ft•lb)
16 Nm (1.6 m•kg, 11 ft•lb)
7 Nm (0.7 m•kg, 5.1 ft•lb)