SECTION 6—ARMS
Using/Installing/Adjusting Non-Locking Cantilever
Arms
Using Non-Locking Cantilever Arms
WARNING
DO NOT use lap trays with non-locking
cantilever arms.
NOTE: For this procedure, refer to
FIGURE 6.9.
1. Pull the end of the cantilever arm down
to lower the cantilever arm.
2. Pull the end of the cantilever arm up to
move it out of the way.
Installing Non-Locking Cantilever Arms
NOTE: For this procedure, refer to FIGURE 6.10.
1. Remove the locknut and washer from the lower hex bolt installed on the non‐locking
cantilever arm.
2. Slide the hex bolt of the cantilever arm assembly into the desired mounting hole on the
back cane.
3. Secure the cantilever arm to the wheelchair with a washer and locknut.
4. Adjust the angle of the cantilever arm, if necessary. Refer to Adjusting Non‐Locking
Cantilever Arm Angle on page 53.
Adjusting Non-Locking Cantilever Arm Height
NOTE: For this procedure, refer to FIGURE 6.10.
1. Remove the locknut and washer from
the lower hex bolt securing the
cantilever arm to the back cane.
2. Slide the cantilever arm assembly out
of the back cane.
3. Reposition the cantilever arm assembly
to the desired mounting hole.
4. Secure the cantilever arm to the
wheelchair with a washer and locknut.
Compass™XE and Allegro®
REAR OF
WHEELCHAIR
FIGURE 6.9 Using Non-Locking Cantilever
Coved
Washers and
Spacer
Lower
Hex Bolt
FIGURE 6.10 Adjusting Non-Locking
Cantilever Arm Height
52
Back Cane
Cantilever Arm
Arms
Back Cane
Locknut
Washer
Cantilever Arm
Part No 1127114