Recliner Operation - Invacare Compass XE Owner's Operator And Maintenance Manual

Hide thumbs Also See for Compass XE:
Table of Contents

Advertisement

SECTION 11—RECLINER

Recliner Operation

WARNING
Both gas cylinders MUST be operational and adjusted properly BEFORE using
recliner. DO NOT operate the recliner option if only one of the gas cylinders is
operational or adjusted properly.
ALWAYS make sure that the wheelchair is stable in the full reclined (back at 170°)
position and the full upright (back at 90°) position BEFORE using the recliner
option.
Make sure the patient is properly positioned in the wheelchair before reclining or
inclining (reverse recline) to maintain maximum stability and safety. Refer to
Safety/Handling of Wheelchairs on page 20.
ALWAYS use the seat positioning strap.
The seat positioning strap is a positioning belt only. It is not designed for use as a
safety device withstanding high stress loads such as auto or aircraft safety belts. If
signs of wear appear, seat positioning strap MUST be replaced immediately.
ALWAYS engage both wheel locks while reclining or inclining (reverse recline) the
wheelchair.
When returning the occupant of the wheelchair to the full upright position, more
body strength will be required for approximately the last twenty (20) degrees of
incline (reverse recline). Make sure to use proper body mechanics (use your legs) or
seek assistance to avoid injury.
Before using the recliner option, make sure the anti-tipper wheel assemblies are in
the lowest adjustment hole (adjustment hole closest to the ground/floor).
NEVER use the rear two recliner bracket mounting holes when using the recliner
option. Using the rear two recliner bracket mounting holes WILL make the
wheelchair less stable, possibly causing injury.
See Warning above.
X
X
NEVER use the rear two
recliner bracket mounting holes
See Warning above.
Before using ANY recline position of this wheelchair, make sure the rear wheels are
in the MOST REARWARD position to maintain the stability of the wheelchair. Do
not change the handling/maneuverability of the wheelchair by moving the rear
wheels to any of the forward positions. Moving the rear wheels to any of the forward
positions WILL change the center of gravity of the wheelchair, making the wheel-
chair less stable.
115
Part No 1127114
Compass™XE and Allegro®

Advertisement

Table of Contents
loading

This manual is also suitable for:

Compass allegro

Table of Contents