DO NOT inflate tire until it is completely assembled.
7. Inflate the tire to the correct p.s.i. rating on the sidewall of the tire.
Make sure detent pin and locking pins of the quick/quad-release axles are fully
released before operating the wheelchair.
8. Reinstall rear wheel to the wheelchair.
9. If the locking pins of the quick/quad‐
release axles are not protruding past
the inside of the axle bushing or there is
too much movement of the rear wheel
assembly in a back and forth position,
Refer to Adjusting the Quick‐Release
Axle on page 103 or Adjusting the
Quad‐Release Axle on page 104.
10. Repeat the procedure for the opposite
rear wheel if necessary.
Repairing/Replacing Rear Wheel Tire/Tube
Replacement of a rear wheel tire or tube MUST be performed by a qualified
technician.
Part No 1127114
WARNING
WARNING
Handrim
Locknut
FIGURE 10.7 Installing Projection
Handrims Spoke Rear Wheels
WARNING
109
SECTION 10—WHEELS
Mounting
Screw
Compass™XE and Allegro®