Using/Installing/Adjusting Non-Locking Cantilever Arms; Using Non-Locking Cantilever Arms; Installing Non-Locking Cantilever Arms - Invacare Spree XT Owner's Operator And Maintenance Manual

Using/Installing/Adjusting Non-Locking Cantilever
Arms
DO NOT use lap trays with non-locking cantilever arms.

Using Non-Locking Cantilever Arms

WARNING
DO NOT use lap trays with non-locking
cantilever arms.
NOTE: For this procedure, refer to
FIGURE 5.4.
1. Pull the end of the cantilever arm down
to lower the cantilever arm.
2. Pull the end of the cantilever arm up to
move it out of the way.

Installing Non-Locking Cantilever Arms

NOTE: For this procedure, refer to FIGURE 5.5.
1. Remove the locknut and washer from
the lower hex bolt installed on the
non‐locking cantilever arm.
2. Slide hex bolt of the cantilever arm
assembly into the desired back cane
mounting hole.
3. Secure the cantilever arm to the
wheelchair with a washer and locknut.
4. Adjust the angle of the cantilever arm,
if necessary. Refer to Adjusting
Non‐Locking Cantilever Arm Angle on
page 46.
Part No 1118364
WARNING
Rear
FIGURE 5.4 Using Non-Locking Cantilever
Coved Washers and
Spacer
Lower Hex Bolt
FIGURE 5.5 Installing Non-Locking
Cantilever Arms - Adjusting Non-Locking
Cantilever Arm Height
45
SECTION 5—ARMS
Back Cane
Cantilever Arm
Arms
Back Cane
Locknut
Washer
Cantilever Arm
Spree XT