Section 11-Recliner - Invacare Compass XE Owner's Operator And Maintenance Manual

SECTION 11—RECLINER
SECTION 11—RECLINER
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
The seat height, seat depth, back angle, seating system, size/position of the rear
wheels, size/position of the front casters, as well as the user condition directly relate
to the stability of the wheelchair. Any change to one or any combination of the nine
may cause the wheelchair to decrease in stability. These adjustments MUST be per-
formed by an authorized dealer or qualified technician.
NOTE: Refer to the section indicated if any of the following procedures are required.
REPLACEMENT/ADJUSTMENT
Folding/Unfolding the Wheelchair
Replacing Back/Headrest Upholstery
Adjusting the Back Height
Repositioning the Back (Changing Seat Depth)
Repositioning Back For 2 or 3-inch Seat Cushion
Replacing Folding Push Handle
Replacing the Seat Upholstery
Changing/Repositioning Seat Rails
Repositioning the Crossbraces
Changing Seat Width
Compass™XE and Allegro®
WARNING
LOCATION IN MANUAL:
Safety/Handling of Wheelchairs on page 20.
back on page 63.
Adjusting Back Height on page 67.
Repositioning the Back (Changing Seat Depth)
on page 73.
2 or 3-Inch Seat Cushion (Recliners Only) on
page 75.
Replacing Folding Push Handle - Recliners Only
on page 76.
Replacing Seat Upholstery on page 78.
Changing/Repositioning Seat Rails on page 78.
Repositioning the Crossbraces on page 79.
Changing Seat Width on page 80.
114
Part No 1127114