SECTION 10—WHEELS
Permanent Axles
NOTE: To remove rear wheels, reverse this procedure.
1. Remove the permanent axles from the packaged container.
2. Install permanent axle through the rear wheel and axle plate.
3. Securely tighten the wheel to the wheelchair frame with locknut.
NOTE: Only 12‐inch rear wheel is shown. All other wheels will install/remove in the same
manner.
4. Repeat STEPS 2‐3 for other rear wheel assembly.
5. Adjust the wheel locks. Refer to Adjusting the Wheel Locks on page 121.
DETAIL "A" -
QUICK-RELEASE AXLE
Axle Mounting Plate
Locking Pins
Quick Release Axle
DETAIL "B" -
PERMANENT AXLE
Hex Screw
Compass™XE and Allegro®
Outside
Outside
Axle Mounting Plate
FIGURE 10.1 Removing/Installing Rear Wheelss
Inside
Inside
102
NOTE: Non‐Recliner
axle plate shown only
for clarity.
Locknut
NOTE: Non‐Recliner
axle plate shown only
for clarity.
Part No 1127114