SECTION 6—ARMS
Back Cane
Coved Washers
Spacer
Adjustment
Plate
Locknuts
Actuator
Washers
Bottom Hex Bolt
Top Hex Bolt and
Cantilever Arm
Coved Washer
FIGURE 6.6 Using/Installing/Adjusting Cantilever Arms
Adjusting Arm Angle to Corresponding Back Angle
NOTE: For this procedure, refer to FIGURE 6.7 on page 50.
NOTE: This adjustment is recommended if the back angle has been changed to keep arm parallel
to the ground/floor.
1. Flip the cantilever arm up and out of the way.
2. Remove the locknut that secures the locking pin to the adjustment plate (Detail "A").
3. Determine the mounting hole in the arm adjustment plate that will be used to
correspond to the back angle (FIGURE 6.7).
NOTE: Back angles of 105° and 110° will use the same arm adjustment plate mounting holes.
4. Securely tighten the locking pin and washer to the adjustment plate with a locknut.
5. Repeat STEPS 1‐4 for the opposite side, if necessary.
49
Part No 1127114
Compass™XE and Allegro®