Removing/Installing and Adjusting T-Arms
NOTE: For this procedure, refer to FIGURE 5.3.
Removing/Installing T-Arms
NOTE: To remove the T‐arm, reverse this procedure.
1. Align the T‐arm with the socket in the T‐arm bracket on the wheelchair frame.
2. Slide the T‐arm into the T‐arm bracket until the height adjustment screw rests on the
top on the T‐arm bracket.
Adjusting T-Arm Height
NOTE: For this procedure, refer to
FIGURE 5.3.
1. Remove the T‐arm. Refer to Removing/
Installing T‐Arms on page 29.
2. Remove the height adjustment screw
and locknut from the height
adjustment hole.
3. Reinstall the height adjustment screw
and locknut in one of the three height
adjustment holes on the t‐arm of the
armrest. Secure tightly.
4. Reinstall the T‐arm. Refer to Removing/
Installing T‐Arms on page 29.
Adjusting T-Arm Position
NOTE: For this procedure, refer to
FIGURE 5.4
NOTE: T‐arm can be mounted in one of two
locations on the seat rail.
1. Remove the two mounting screws and
locknuts that secure the T‐arm bracket
to the seat rail.
2. Install T‐arm bracket in desired
mounting position on seat rail.
3. Secure the T‐arm bracket to the seat rail
with two mounting screws and
locknuts. Securely tighten.
Part No 1134343
Armrest
Height
Adjustment
Hole
Locknut
T-Arm
Bracket
FIGURE 5.3 Adjusting T-Arm Height
T-Arm
Bracket
Mounting Screws
FIGURE 5.4 Adjusting T-Arm Position
29
SECTION 5—ARMS
Height
Adjustment
Screw
T-Arm
Locknuts
Additional
mounting hole
for T-bracket
™
Crossfire
T6A Wheelchair