SECTION 6—ARMS
Adjusting Non-Locking Cantilever Arm Angle
NOTE: For this procedure, refer to FIGURE 6.11.
1. Loosen the mounting screw securing the cam to the cantilever arm.
2. Rotate the cam until the desired angle is achieved (Detail ʺAʺ of FIGURE 6.11).
3. Tighten the mounting screw securing the cam to the cantilever arm.
Side View of Cam
Back Cane
Cam
Back
Cane
Cantilever Arm
Cantilever
Arm
DETAIL "A" - CAM POSITIONS
0° Arm Angle
4° Arm Angle
8° Arm Angle
12° Arm Angle
16° Arm Angle
Back Cane
Back Cane
Back Cane
Back Cane
Back Cane
Cam
Cam
Cam
Cam
Cam
NOTE: All arm angles are relative to the back cane.
FIGURE 6.11 Adjusting Non-Locking Cantilever Arm Angle
53
Part No 1127114
Compass™XE and Allegro®