Section 6-Arms; Adjusting/Removing/Replacing Conventional Arms; Adjusting Conventional Arm Height; Removing Conventional Arms - Invacare Compass XE Owner's Operator And Maintenance Manual

SECTION 6—ARMS
NEVER try to lift or tip the wheelchair by the arms, serious injury can occur.
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may occur.
Make sure the armrest release levers are secured before using the wheelchair.

Adjusting/Removing/Replacing Conventional Arms

Make sure the armrest release levers are secured before using the wheelchair.
NOTE: For this procedure, refer to FIGURE 6.1 on page 46.

Adjusting Conventional Arm Height

1. Unlock the conventional arm by flipping the armrest release lever on the top front of
the armrest to the up (horizontal) position.
2. Adjust conventional arm to desired height.
3. Lock the conventional arm by pressing the release lever into the down (vertical)
position when the desired armrest height is achieved.

Removing Conventional Arms

1. Unlock the conventional arm by turning the armrest release lever located on the side
rail to the unlocked position.
2. Remove the conventional arm from the wheelchair.

Installing Conventional Arms

NOTE: Armrest release levers must be in the unlocked position when placing armrests into the arm
sockets.
1. Position the conventional arm in the arm sockets and lock the conventional arm by
turning the armrest release levers into the locked position.
Part No 1127114
WARNING
WARNING
45
SECTION 6—ARMS
Compass™XE and Allegro®