SECTION 5—FRONT RIGGINGS
Footplate
Washers
FIGURE 5.12 Replacing Aluminum, Composite/Articulating Footplate Heel Loop - Flip-up
Replacing Sector Block
NOTE: For this procedure, refer to
FIGURE 5.13.
1. Remove the hex screw and washer that
secure the existing sector block to the
wheelchair frame.
2. Position the new sector block on the
wheelchair frame. Make sure the
locking pin is facing up.
3. Secure the new sector block to the
wheelchair frame with the existing hex
screw and washer.
Installing Impact Guards/Calf Strap/H-Calf Strap
NOTE: For this procedure, refer to FIGURE 5.14.
NOTE: Impact guards are standard equipment
on Model ST footrests. No assembly is required.
1. Remove impact guard/calf strap from
packaged container.
2. Secure the impact guards to the footrest
frame.
3. Secure the calf strap around the footrest
frame (with the impact guards
attached).
Compass™XE and Allegro®
Heel Loop
Mounting
Screws
Footplates
Wheelchair
FIGURE 5.13 Replacing Sector Block
FIGURE 5.14 Installing Impact Guards/Calf
44
Mounting
Screws
Frame
Locking Pin
Impact Guard
Strap/H-Calf Strap
Washers
Heel Loop with
Ankle Strap
Footplate
Hex
Screw
Washer
Sector Block
H-Calf Strap
Calf Strap
Part No 1127114