Locking Pin
Wheelchair
Frame
T-Arm Socket
Adjusting T-Arm Transfer Assists and/or Side Guards
NOTE: For this procedure, refer to FIGURE 6.19.
1. Remove the T‐arm for the wheelchair. Refer to Installing/Removing T‐Arms on
page 55.
2. Remove the bottom socket screw that
secures the side guard to the bottom
clamp.
3. Move the bottom clamp to one of three
mounting holes in the side guard.
NOTE: The bottom mounting hole is the
standard mounting position for folding
wheelchairs.
NOTE: The middle mounting hole in the
standard mounting position for rigid
wheelchairs.
NOTE: The top mounting hole is an optional
mounting position for folding or rigid
wheelchairs.
4. Secure the side guard to the bottom
clamp with the socket screw.
5. Install the T‐arm onto the wheelchair.
Refer to Installing/Removing T‐Arms
on page 55.
Part No 1127114
Hex Screw
Optional
Washer
T-Arm
Clamp
FIGURE 6.18 Adjusting T-Arm Sockets
Hex Screws
and Washers
T-Arm Socket
Top
Middle
Bottom
Side
Guard
Socket
Screws
FIGURE 6.19 Adjusting T-Arm Transfer
Assists and/or Side Guards
59
SECTION 6—ARMS
T-Arm
Hex
Screws and
Washers
T-arm
Socket
Transfer
Assist
Bottom Clamp
Compass™XE and Allegro®