Washer
Locknut
FIGURE 7.6 Adjusting Back Height - Fixed Height Backs
Recliner Backs
NOTE: For this procedure, refer to FIGURE 7.7 on page 70.
1. Press the push pins on the headrest extension tubes in and remove the headrest
extension from the back canes.
2. Remove the existing recliner back upholstery from the wheelchair. Refer to Replacing
Standard Back Upholstery on page 63.
3. Remove the mounting screws and locknuts that secure the existing folding push
handle and trigger release levers to the back cane.
4. Remove the folding handle from the wheelchair.
5. Cut the tie wraps that secure the recliner cables to the existing back canes.
6. Remove the socket bolts, washers and locknuts that secure the actuator housing to the
existing back canes.
7. Remove the socket bolts, coved washers, washers and locknuts that secure the existing
back canes to the recliner brackets.
8. Remove existing back canes from the recliner brackets.
The back canes MUST be fastened securely to the seat frame BEFORE using the
wheelchair.
9. Position the new back canes on the recliner brackets and tighten securely with the
socket bolts, coved washers, washers and locknuts.
10. Position the actuator housings on the new back canes and tighten securely with the
socket bolts, washers and locknuts.
11. Secure the recliner cables to the new back canes with tie wraps.
12. Insert the folding handle into the new back canes.
Part No 1127114
Back Cane
WARNING
69
SECTION 7—BACK
Hex Bolt
Back Angle Plate
Compass™XE and Allegro®