SECTION 6—ARMS
Adjusting the T-Arms
Height
NOTE: For this procedure, refer to FIGURE 6.14.
1. Unlock the T‐arm by flipping the T‐arm release lever towards the inside of the
wheelchair.
NOTE: If necessary, pull out on the T‐arm release lever and rotate 180° so it can be flipped towards
the outside of the wheelchair.
2. Slide the T‐arm to desired height:
• Low Height T‐arms ‐ Nine positions.
• High Height T‐arms ‐ Seven positions.
NOTE: If the inside T‐arm post does not slide
up and down in the outside T‐arm post as
desired, perform one of the following:
• Tighten ‐ Tightening the set screws on
the outside T‐arm post will make it
harder to move the inside T‐arm post up
and down.
• Loosen ‐ Loosening the set screws on the
outside T‐arm post will make it easier to
move the inside T‐arm post up and
down.
3. Lock the T‐arm by flipping the T‐arm
release lever towards the front of the
wheelchair.
Width
NOTE: For this procedure, refer to
FIGURE 6.15.
1. Remove the two mounting screws that
secure the arm pad to the arm tube.
2. Turn the arm pad around and
reposition the arm pad on the arm tube.
3. Secure the arm pad to the arm tube
with the two mounting screws.
4. Repeat STEPS 1‐3 for the opposite side,
if necessary.
Compass™XE and Allegro®
Set Screws
Outside
T-Arm
Post
FIGURE 6.14 Adjusting the T-Arms -
Pad
Arm
Mounting
Screw
FIGURE 6.15 Adjusting the T-Arms -
56
T-Arm Release Lever
- Unlocked Position
Inside T-Arm
Arm Post
Arm Post
Height
Arm Tube
Mounting
Screw
Width
Part No 1127114