Section 5-Rear Wheels/Front Casters; Removing/Installing Rear Wheels; Fixed Axles, Transit Version - Invacare Action 4 NG Heavy Duty Service Manual

Hide thumbs Also See for Action 4 NG Heavy Duty:
Table of Contents

Advertisement

SECTION 5—REAR WHEELS/FRONT CASTORS
The seat height, seat depth, back angle, seating system, size/position of the
rear wheels, size/position of the front castors, seating options (e.g. headrest,
back bag, ...) as well as the user condition directly relate to the stability of
the wheelchair. Any change to one or any combination of the nine may cause
the wheelchair to decrease in stability.
After ANY adjustments, repair, or service and before use, make sure all
attaching hardware is tightened securely - otherwise injury or damage
may occur.

Removing/Installing Rear Wheels

If changing the size of the rear wheel or the seat-to-floor height, refer to
the table of the next page.
F i x e d A x l e s , T r a n s i t v e r s i o n
NOTE: For this procedure, refer to FIGURE 5.1, next page.
Removing rear wheels
1. 12"; remove the fixed axle, washers, dust cap and locknut that secure rear wheel to
the axle brackets. Remove existing rear wheel from the wheelchair.
2. Install new/existing rear wheel onto wheelchair. Refer to Installing Transit Kit
paragraph see STEPS 3-6 only.
3. 24" or 22"; remove the complete wheel and the axle bracket from the axle plate.
Refer to Removing/Installing Rear Wheels paragraph.
Installing Transit Kit
1. Always make sure that the axle plate is in the passive position on both sides, refer to
Adjusting the Wheelbase Length paragraph.
2. Install the axle bracket and anti-tippers bracket with the Axle Brackets Hardware
3. Install fixed axle through washer, new/existing rear wheel, and axle bracket.
4. Securely tighten with the existing fixed axle locknut. Torque to 25 Nm.
5. Fixed and adjust the transit brake with its brake hardware, adjust the distance
between the brake shoe and the wheel, see Adjusting Wheel Brake paragraph.
6. If necessary, repeat STEPS 1
NOTE: Both Axle brackets should be set at the same position. Head of bottom mounting
screws needs to be on the outside position.
SECTION 5—REAR WHEELS/FRONT CASTORS
W A R N I N G
W A R N I N G
5 for opposite rear wheel.
-
2 7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Action 4 ng seriesAction 4 ng comfort

Table of Contents