Table of Contents
Advertisement
SECTION 5—REAR WHEELS/FRONT CASTORS
SECTION 5—REAR WHEELS/FRONT CASTORS
The seat height, seat depth, back angle, seating system, size/position of the
rear wheels, size/position of the front casters, seating options (e.g. headrest,
back bag, ...) as well as the user condition directly relate to the stability of
the wheelchair. Any change to one or any combination of the nine may cause
the wheelchair to decrease in stability.
After ANY adjustments, repair or service and before use, make sure all
attaching hardware is tightened securely - otherwise injury or damage may
occur.
Removing/Installing Rear Wheels
If changing the size of the rear wheel or the seat-to-floor height, refer to
the table in the next page.
F i x e d Ax l e s , T r a n s i t v e r s i o n
Removing rear wheels
1. 12"; remove the fixed axle, washers and locknut that secure rear wheel to the axle
bracket. Remove existing rear wheel from the wheelchair.
2. Install new/existing rear wheel onto wheelchair. Refer to Installing Transit Kit
paragraph, see STEPS 3-6 only.
3. 24" or 22"; remove the complete wheel and the axle bracket from the side frame.
Refer to Removing/Installing Rear Wheels paragraph.
Installing Transit Kit
1. Always make sure that the axle plate is in the passive position on both sides, refer to
Adjusting the Wheel Base Length paragraph.
2. Install the axle bracket with the Axle brackets Hardware
3. Install fixed axle through washer, new/existing rear wheel and axle bracket.
4. Securely tighten with the existing fixed axle locknut. Torque to 25 Nm.
5. Fixed and adjust the transit brake with its brake hardware, adjust the distance
between the brake shoe and the wheel, see Adjusting Wheel Brake paragraph.
6. If necessary, repeat STEPS 1
NOTE: Both Axle brackets should be set at the same position. Head of bottom mounting
screws needs to be on the outside position.
W A R N I N G
W A R N I N G
5 for opposite rear wheel.
-
1 6
Advertisement
Table of Contents
