10 Enclosure Bay IP Addressing commands
ADD EBIPA
Command:
ADD EBIPA { BLADE | INTERCONNECT } DNS <ip address> [ { , | - } <bay
number> ]
NOTE:
Description:
Adds a DNS server IP address to the list of DNS servers for either BLADE bays or
INTERCONNECT bays
Access Level/Bay level:
Administrator, Operator
Restrictions:
◦
A maximum of three DNS servers can be added for EBIPA.
◦
The <ip address> must be in the form ###.###.###.###, where each ### ranges
from 0 to 255.
DISABLE EBIPA
CAUTION:
Command:
DISABLE EBIPA {BLADE|INTERCONNECT} [ALL | <bay number> [{ , | - }
<bay number>]]
Description:
Disables the ability of the Onboard Administrator to give devices in the bays IP addresses
using DHCP.
If no bay numbers are specified, then EBIPA is disabled for all bays. Devices in bays receive
IP addresses from an external server.
This causes a reset of the iLO, which causes it to attempt to get an IP address from an external
DHCP server. The interconnect is power-cycled.
Access level/Bay level:
Administrator, Operator
Restrictions:
None
ENABLE EBIPA
CAUTION:
Command:
ENABLE EBIPA {BLADE|INTERCONNECT} [ALL | <bay number> [{ , | - }
<bay number>]]
SERVER is a valid alias for BLADE.
This command cycles power to the interconnect and causes a loss of connectivity.
This command cycles power to the interconnect and causes a loss of connectivity.
ADD EBIPA
51