Display Cfd Service-Instance - HP 6125XLG Command Reference Manual

Field
MAC Address
State
Time
MAC Status

display cfd service-instance

Use display cfd service-instance to display the configuration information of service instances.
Syntax
display cfd service-instance [ instance-id ]
Views
Any view
Predefined user roles
network-admin
network-operator
Parameters
instance-id: Service an instance ID in the range of 1 to 32767. If this argument is not specified, the
configuration information of all service instances is displayed.
Examples
# Display the configuration information of all service instances.
<Sysname> display cfd service-instance
Service instances configured (2 in total):
Service instance 5:
Maintenance domain: md_5
Maintenance domain index: 5
Maintenance association: ma_5
Maintenance association index: 5
Level: 5
MEP ID: 730
Description
MAC address of the remote MEP device.
If this field is not supported, a hyphen (-) is displayed.
Running state of the remote MEP, OK or FAILED.
Time when the remote MEP entered the FAILED or OK state for the last time.
State of the interface indicated by the last CCM received from the remote
MEP:
•
•
•
•
•
•
•
If this field is not supported, a hyphen (-) is displayed.
VLAN: 5 MIP rule: NONE
Interface: Ten-GigabitEthernet1/1/5
UP—The interface is ready to pass packets.
DOWN—The interface cannot pass packets.
TESTING—The interface is in some test mode.
UNKNOWN—The interface status cannot be determined.
DORMANT—The interface is not in a state to pass packets. Instead, it is in
a pending state, waiting for some external event.
NOT-PRESENT—Some component of the interface is missing.
LLD—The interface is down due to state of the lower layer interfaces.
CCM interval: 1s
50
Direction: Inbound