HP 6125XLG Command Reference Manual page 117

Local Discr: 513
Source IP: FE80::20C:29FF:FED4:7171
Destination IP: FE80::20C:29FF:FE72:AC4D
Session State: Up
Min Tx Inter: 500ms
Min Rx Inter: 500ms
Rx Count: 38
Connect Type: Direct
Hold Time: 2211ms
Detect Mode: Async
Protocol: OSPF6
Diag Info: No Diagnostic
Table 32 Command output
Field
Total Session Num
Up Session Num
Init Mode
Session Working Under Ctrl Mode
Local Discr/LD
Remote Discr/RD
Source IP/SourceAddr
Destination IP/DestAddr
Session State/State
Interface
Min Tx Inter
Min Rx Inter
Act Tx Inter
Detect Inter
Rx Count
Tx Count
Hold Time/Holdtime
Auth mode
Connect Type
Running up for
Detect Mode
Remote Discr: 513
Interface: Vlan-interface11
Act Tx Inter: 500ms
Detect Inter: 2500ms
Tx Count: 38
Running Up for: 00:00:15
Auth mode: None
Slot: 1
Description
Total number of BFD sessions.
Total number of active BFD sessions.
BFD operating mode, active or passive.
IPv4/IPv6 BFD session mode:
•
Ctrl—Control packet mode.
•
Echo—Echo packet mode.
Local ID of the session.
Remote ID of the session.
Source IP address of the session.
Destination IP address of the session.
Session state: up or down.
Name of the interface of the session.
Minimum transmit interval.
Minimum receive interval.
Actual transmit interval.
Actual session detection timer.
Number of packets received.
Number of packets sent.
Length of time before session detection timer expires.
Session authentication mode (only simple is supported).
Connection type of the interface, direct or indirect.
Time interval for which the session has been up.
Detection mode:
•
Async—Asynchronous mode.
•
Demand—Demand mode.
1 12