Vrrp Ipv6 Vrid Priority - HP 6125XLG Command Reference Manual

To avoid frequent state changes among members in a VRRP group and to provide the backups enough
time to collect information (such as routing information), a backup does not immediately become the
master after it receives an advertisement with lower priority than the local priority. Instead, it waits for a
period of time before taking over as the master.
Examples
# Enable the preemptive mode for VRRP group 1, and set the preemption delay time to 5 seconds.
<Sysname> system-view
[Sysname] interface vlan-interface 2
[Sysname-Vlan-interface2] vrrp ipv6 vrid 10 preempt-mode delay 5
Related commands
display vrrp ipv6

vrrp ipv6 vrid priority

Use vrrp ipv6 vrid priority to configure the priority of the router in an IPv6 VRRP group.
Use undo vrrp ipv6 vrid priority to restore the default.
Syntax
vrrp ipv6 vrid virtual-router-id priority priority-value
undo vrrp ipv6 vrid virtual-router-id priority
Default
The priority of a router in an IPv6 VRRP group is 100.
Views
Interface view
Predefined user roles
network-admin
Parameters
virtual-router-id: Specifies an IPv6 VRRP group by its virtual router ID in the range of 1 to 255.
priority-value: Specifies a priority value in the range of 1 to 254. A higher number indicates a higher
priority.
Usage guidelines
VRRP determines the role (master or backup) of each router in a VRRP group by priority. A router with a
higher priority is more likely to become the master.
VRRP priority is in the range of 0 to 255, and a greater number represents a higher priority. Priorities 1
to 254 are configurable. Priority 0 is reserved for special uses, and priority 255 is for the IP address
owner. The router acting as the IP address owner in a VRRP group always has a running priority of 255
and acts as the master as long as it operates properly.
Examples
# Configure the priority of the device in VRRP group 1 on VLAN-interface 2 as 150.
<Sysname> system-view
[Sysname] interface vlan-interface 2
93