Configuration Procedure - HP 6125XLG Configuration Manual

Blade switch ip multicast configuration guide
Table of Contents

Advertisement

Figure 18 Network diagram
Switch A
Vlan-int200
50.1.1.1/24

Configuration procedure

1.
Configure the IP address and subnet mask for each interface as shown in
shown.)
2.
Enable OSPF on the switches in the PIM-DM domain to make sure the network-layer on the PIM-DM
network is interoperable and the routing information among the switches can be dynamically
updated. (Details not shown.)
3.
Enable IP multicast routing, and enable IGMP and PIM-DM:
# On Switch B, enable IP multicast routing globally, enable IGMP on VLAN-interface 100, and
enable PIM-DM on each interface.
<SwitchB> system-view
[SwitchB] multicast routing-enable
[SwitchB] interface vlan-interface 100
[SwitchB-Vlan-interface100] igmp enable
[SwitchB-Vlan-interface100] pim dm
[SwitchB-Vlan-interface100] quit
[SwitchB] interface vlan-interface 101
[SwitchB-Vlan-interface101] pim dm
[SwitchB-Vlan-interface101] quit
[SwitchB] interface vlan-interface 102
[SwitchB-Vlan-interface102] pim dm
[SwitchB-Vlan-interface102] quit
# On Switch A, enable IP multicast routing globally and enable PIM-DM on each interface.
<SwitchA> system-view
[SwitchA] multicast routing-enable
[SwitchA] interface vlan-interface 200
[SwitchA-Vlan-interface200] pim dm
[SwitchA-Vlan-interface200] quit
Vlan-int103
40.1.1.1/24
Vlan-int103
40.1.1.2/24
Vlan-int102
30.1.1.2/24
Source
50.1.1.100/24
Multicast static route
Switch C
Vlan-int101
20.1.1.2/24
PIM-DM
Vlan-int101
20.1.1.1/24
Vlan-int102
30.1.1.1/24
Receiver
10.1.1.100/24
41
Switch B
Vlan-int100
10.1.1.1/24
Figure
18. (Details not

Advertisement

Table of Contents
loading

Table of Contents