HP 6125XLG Configuration Manual page 96

[SwitchD-pim] c-rp 192.168.4.2 group-policy 2005
[SwitchD-pim] quit
# On Switch E, configure the service scope of RP advertisements, configure VLAN-interface 102 as
a C-BSR and a C-RP, and set the hash mask length to 32 and the priority of the C-BSR to 20.
<SwitchE> system-view
[SwitchE] acl number 2005
[SwitchE-acl-basic-2005] rule permit source 225.1.1.0 0.0.0.255
[SwitchE-acl-basic-2005] quit
[SwitchE] pim
[SwitchE-pim] c-bsr 192.168.9.2 hash-length 32 priority 20
[SwitchE-pim] c-rp 192.168.9.2 group-policy 2005
[SwitchE-pim] quit
Verifying the configuration
# Display PIM information on Switch A.
[SwitchA] display pim interface
Interface
Vlan100
Vlan101
Vlan102
# Display BSR information on Switch A.
[SwitchA] display pim bsr-info
Scope: non-scoped
State: Accept Preferred
Bootstrap timer: 00:01:44
Elected BSR address: 192.168.9.2
Priority: 20
Hash mask length: 32
Uptime: 00:40:40
# Display BSR information on Switch D.
[SwitchD] display pim bsr-info
Scope: non-scoped
State: Candidate
Bootstrap timer: 00:01:44
Elected BSR address: 192.168.9.2
Priority: 20
Hash mask length: 32
Uptime: 00:05:26
Candidate BSR address: 192.168.4.2
Priority: 10
Hash mask length: 32
# Display BSR information on Switch E.
[SwitchE] display pim bsr-info
Scope: non-scoped
State: Elected
Bootstrap timer: 00:01:44
Elected BSR address: 192.168.9.2
NbrCnt HelloInt DR-Pri
0 30 1
1 30 1
1 30 1
89
DR-Address
10.110.1.1 (local)
192.168.1.2
192.168.9.2