Configuring Switchover To Spt; Configuring Common Ipv6 Pim Features; Configuration Task List - HP 6125XLG Configuration Manual

To configure IPv6 multicast source registration:
Step
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure a filtering rule for
register messages.
4. Configure the device to
calculate the checksum based
on the entire register
message.

Configuring switchover to SPT

CAUTION:
If the router is an RP, disabling switchover to SPT might cause multicast traffic forwarding failures on the
source-side DR. When disabling switchover to SPT, be sure you fully understand its impact on your
network.
To configure switchover to SPT
Step
1. Enter system view.
2. Enter IPv6 PIM view.
3. Configure the criteria for
triggering a switchover to SPT.

Configuring common IPv6 PIM features

Configuration task list

Task at a glance
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
(Optional.)
Configuring an IPv6 multicast data filter
Configuring a hello message filter
Configuring IPv6 PIM hello message options
Configuring common IPv6 PIM timers
Setting the maximum size of each join or prune message
Enabling IPv6 PIM to work with BFD
Command
system-view
ipv6 pim
register-policy acl6-number
register-whole-checksum
Command
system-view
ipv6 pim
spt-switch-threshold { immediacy |
infinity } [ group-policy
acl6-number ]
156
Remarks
N/A
N/A
By default, no register filtering rule
exists.
By default, the device calculates
the checksum based on the header
of a register message.
Remarks
N/A
N/A
By default, both the receiver-side
DR and RP immediately trigger the
switchover from RPT to SPT after
receiving the first multicast packet.