Ipv6 Pim-Sm Non-Scoped Zone Configuration Example - HP 6125XLG Configuration Manual

Protocol: pim-dm, Flag: ACT
UpTime: 00:01:20
Upstream interface: Vlan-interface103
Upstream neighbor: 1002::2
RPF prime neighbor: 1002::2
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface100
# Display IPv6 PIM multicast routing table information on Switch D.
[SwitchD] display ipv6 pim routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(4001::100, FF0E::101)
Protocol: pim-dm, Flag: LOC ACT
UpTime: 00:02:19
Upstream interface: Vlan-interface300
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 2
1: Vlan-interface103
2: Vlan-interface102

IPv6 PIM-SM non-scoped zone configuration example

Network requirements
As shown in
subnets form stub networks, and at least one receiver host exist in each stub network. The entire IPv6
PIM-SM domain contains only one BSR.
Host A and Host C are multicast receivers in the stub networks N1 and N2.
VLAN-interface 105 on Switch D and VLAN-interface 102 on Switch E act as C-BSRs and C-RPs. The
C-BSR on Switch E has a higher priority. The C-RPs provide services for the IPv6 multicast group range
FF0E::101/64. Modify the hash mask length to map the IPv6 multicast group range to the two C-RPs.
MLDv1 runs between Switch A and N1, and between Switch B, Switch C, and N2.
Protocol: pim-dm, UpTime: 00:01:20, Expires: -
Protocol: pim-dm, UpTime: 00:02:19, Expires: -
Protocol: pim-dm, UpTime: 00:02:19, Expires: -
Figure 54, VOD streams are sent to receiver hosts in multicast. The receivers of different
165