Configuring Rip Route Redistribution - HP 6125XLG Configuration Manual

[SwitchB-rip-1] filter-policy prefix-list bbb export
[SwitchB-rip-1] quit
# Display the RIP routing table on Switch A.
[SwitchA] display rip 100 route
Route Flags: R - RIP
----------------------------------------------------------------------------
Peer 192.168.1.2 on Vlan-interface100
# Display the RIP routing table on Switch B.
[SwitchB] display rip 1 route
Route Flags: R - RIP
----------------------------------------------------------------------------
Peer 192.168.1.3 on Vlan-interface100

Configuring RIP route redistribution

Network requirements
As shown in
RIP 200.
Configure RIP 200 to redistribute direct routes and routes from RIP 100 on Switch B so Switch C can learn
routes destined for 10.2.1.0/24 and 1 1.1.1.0/24. Switch A cannot learn routes destined for 12.3.1.0/24
and 16.4.1.0/24.
Figure 8 Network diagram
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Configure basic RIP:
# Enable RIP 100, and configure RIPv2 on Switch A.
<SwitchA> system-view
[SwitchA] rip 100
[SwitchA-rip-100] network 10.0.0.0
[SwitchA-rip-100] network 11.0.0.0
[SwitchA-rip-100] version 2
[SwitchA-rip-100] undo summary
A - Aging, S - Suppressed, G - Garbage-collect
Destination/Mask
10.1.1.0/24
A - Aging, S - Suppressed, G - Garbage-collect
Destination/Mask
172.16.1.0/24
Figure 8, Switch B communicates with Switch A through RIP 100 and with Switch C through
Nexthop Cost
192.168.1.2 1
Nexthop Cost
192.168.1.3 1
36
Tag Flags Sec
0 RA 19
Tag Flags Sec
0 RA 19