Configuring Ospfv3 Route Redistribution - HP 6125XLG Configuration Manual

2.2.2.2
3.3.3.3
4.4.4.4
# Display neighbor information on Switch D. Switch D is still the DR.
[SwitchD] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
1.1.1.1
2.2.2.2
3.3.3.3
4. Restart DR and BDR election:
# Use the shutdown and undo shutdown commands on interfaces to restart DR and BDR election.
(Details not shown.)
# Display neighbor information on Switch A. The output shows that Switch C becomes the BDR.
[SwitchA] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
2.2.2.2
3.3.3.3
4.4.4.4
# Display neighbor information on Switch D.
[SwitchD] display ospfv3 peer
Area: 0.0.0.0
-------------------------------------------------------------------------
Router ID
1.1.1.1
2.2.2.2
3.3.3.3
The output shows that Switch A becomes the DR.

Configuring OSPFv3 route redistribution

Network requirements
As shown in
Switch A, Switch B, and Switch C are in Area 2.
•
0 2-Way/DROther
2 Full/Backup
1 Full/DR
OSPFv3 Process 1 with Router ID 4.4.4.4
Pri State
100 Full/DROther
0 Full/DROther
2 Full/Backup
OSPFv3 Process 1 with Router ID 1.1.1.1
Pri State
0 Full/DROther
2 Full/Backup
1 Full/DROther
OSPFv3 Process 1 with Router ID 4.4.4.4
Pri State
100 Full/DR
0 2-Way/DROther
2 Full/Backup
Figure 78:
00:00:36 Vlan200
00:00:35 Vlan200
00:00:33 Vlan200
Dead-Time Interface
00:00:30 Vlan100
00:00:37 Vlan200
00:00:31 Vlan100
Dead-Time Interface
00:00:36 Vlan200
00:00:35 Vlan100
00:00:33 Vlan200
Dead-Time Interface
00:00:30 Vlan100
00:00:37 Vlan200
00:00:31 Vlan100
320
0
0
0
Inst ID
0
0
0
Inst ID
0
0
0
Inst ID
0
0
0