HP 6125XLG Configuration Manual page 107

The output shows that the DR and BDR are not changed, because the priority settings do not take
effect immediately.
4. Restart OSPF process:
# Restart the OSPF process of Switch D.
<SwitchD> reset ospf 1 process
Warning : Reset OSPF process? [Y/N]:y
# Display neighbor information of Switch D.
<SwitchD> display ospf peer verbose
OSPF Process 1 with Router ID 4.4.4.4
Area 0.0.0.0 interface 192.168.1.4(Vlan-interface1)'s neighbors
Router ID: 1.1.1.1
State: Full
DR: 192.168.1.1
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 39
Neighbor is up for 00:01:40
Authentication Sequence: [ 0 ]
Router ID: 2.2.2.2
State: 2-Way
DR: 192.168.1.1
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 35
Neighbor is up for 00:01:44
Authentication Sequence: [ 0 ]
Router ID: 3.3.3.3
State: Full
DR: 192.168.1.1
Options is 0x02 (-|-|-|-|-|-|E|-)
Dead timer due in 39
Neighbor is up for 00:01:41
Authentication Sequence: [ 0 ]
If the neighbor state is full, Switch D has established an adjacency with the neighbor. If the
neighbor state is 2-way, the two switches are not the DR or the BDR, and they do not exchange
LSAs.
# Display OSPF interface information.
[SwitchA] display ospf interface
OSPF Process 1 with Router ID 1.1.1.1
Area: 0.0.0.0
IP Address
Neighbors
Address: 192.168.1.1
Mode: Nbr is Slave
BDR: 192.168.1.3
sec
Address: 192.168.1.2
Mode: None Priority: 0
BDR: 192.168.1.3
sec
Address: 192.168.1.3
Mode: Nbr is Slave
BDR: 192.168.1.3
sec
Interfaces
Type State
96
Priority: 100
MTU: 0
MTU: 0
Priority: 2
MTU: 0
Cost Pri DR
GR State: Normal
GR State: Normal
GR State: Normal
BDR