HP 6125XLG Configuration Manual page 182

To configure BGP, perform the following tasks (IPv6):
Tasks at a glance
Configuring basic BGP:
•
(Required.) Enabling BGP
•
(Required.) Perform one of the following tasks:
Configuring a BGP peer
Configuring a BGP peer group
•
(Optional.) Specifying the source interface for TCP connections
Generating BGP routes:
•
Perform at least one of the following tasks:
Injecting a local network
Redistributing IGP routes
(Optional.) Controlling route distribution and
•
Configuring BGP route summarization
•
Advertising optimal routes in the IP routing table
•
Advertising a default route to a peer or peer group
•
Limiting routes received from a peer or peer group
•
Configuring BGP route filtering policies
•
Configuring BGP route dampening
(Optional.) Controlling BGP path
•
Specifying a preferred value for routes received
•
Configuring preferences for BGP routes
•
Configuring the default local preference
•
Configuring the MED attribute
•
Configuring the NEXT_HOP attribute
•
Configuring the AS_PATH attribute
(Optional.) Tuning and optimizing BGP
•
Configuring the keepalive interval and hold time
•
Configuring the interval for sending updates for the same route
•
Enabling BGP to establish an EBGP session over multiple hops
•
Enabling immediate reestablishment of direct EBGP connections upon link failure
•
Enabling 4-byte AS number suppression
•
Configuring MD5 authentication for BGP
•
Configuring BGP load balancing
•
Disabling BGP to establish a session to a peer or peer group
•
Configuring BGP soft-reset
•
Protecting an EBGP peer when memory usage reaches level 2 threshold
(Optional.) Configuring a large-scale BGP
•
Configuring BGP community
•
Configuring a BGP route reflector
•
Configuring a BGP confederation
(Optional.) Configuring BGP GR
(Optional.) Enabling trap
reception:
selection:
networks:
network:
171
Remarks
HP recommends
configuring BGP peer
groups on large scale
BGP networks for easy
configuration and
maintenance.
N/A
N/A
N/A
N/A
N/A
N/A
N/A