Ospf Configuration Task List - HP 6125XLG Configuration Manual

RFC 3137, OSPF Stub Router Advertisement
•
• RFC 481 1, OSPF Out-of-Band LSDB Resynchronization
RFC 4812, OSPF Restart Signaling
•
RFC 4813, OSPF Link-Local Signaling
•

OSPF configuration task list

To run OSPF, you must first enable OSPF on the router. Make a proper configuration plan to avoid
incorrect settings that can result in route blocking and routing loops.
To configure OSPF, perform the following tasks:
Tasks at a glance
(Required.)
(Optional.)
•
Configuring a stub area
•
Configuring an NSSA area
•
Configuring a virtual link
(Optional.)
•
Configuring the broadcast network type for an interface
•
Configuring the NBMA network type for an interface
•
Configuring the P2MP network type for an interface
•
Configuring the P2P network type for an interface
(Optional.)
•
Configuring OSPF route summarization
Configuring route summarization on an ABR
Configuring route summarization when redistributing routes into OSPF on an ASBR
•
Configuring inbound OSPF route filtering
•
Configuring Type-3 LSA filtering
•
Configuring an OSPF cost for an interface
•
Configuring the maximum number of ECMP routes
•
Configuring OSPF preference
•
Configuring OSPF route redistribution
Configuring OSPF to redistribute routes from another routing protocol
Configuring OSPF to redistribute a default route
Configuring default parameters for redistributed routes
•
Advertising a host route
Enabling OSPF
Configuring OSPF areas:
Configuring OSPF network
Configuring OSPF route
types:
control:
55