HP 6125XLG Configuration Manual page 100

Configure Switch D as the ASBR to redistribute static routes.
•
• Configure Area 1 as a stub area to reduce advertised LSAs without influencing reachability.
Figure 23 Network diagram
Switch A
Vlan-int200
10.2.1.1/24
Vlan-int200
Area 1
10.2.1.2/24
Stub
Switch C
Configuration procedure
1. Configure IP addresses for interfaces. (Details not shown.)
2. Enable OSPF (see
3. Configure route redistribution:
# Configure Switch D to redistribute static routes.
<SwitchD> system-view
[SwitchD] ip route-static 3.1.2.1 24 10.5.1.2
[SwitchD] ospf
[SwitchD-ospf-1] import-route static
[SwitchD-ospf-1] quit
# Display ABR/ASBR information on Switch C.
<SwitchC> display ospf abr-asbr
Type
Intra
Inter
# Display OSPF routing table on Switch C.
<SwitchC> display ospf routing
Routing for Network
Destination
10.2.1.0/24
10.3.1.0/24
10.4.1.0/24
10.5.1.0/24
Area 0
Vlan-int100
10.1.1.1/24
Vlan-int100
10.1.1.2/24
Vlan-int300
Vlan-int300
10.4.1.1/24
10.5.1.1/24
"Configuring basic
OSPF Process 1 with Router ID 10.4.1.1
Routing Table to ABR and ASBR
Destination
10.2.1.1
10.5.1.1
OSPF Process 1 with Router ID 10.4.1.1
Routing Tables
Cost
3
7
3
17
Switch B
Vlan-int200
10.3.1.1/24
Vlan-int200
Area 2
10.3.1.2/24
ASBR
Switch D
OSPF").
Area
0.0.0.1
0.0.0.1
Type NextHop
Transit 10.2.1.2
Inter 10.2.1.1
Stub 10.4.1.1
Inter 10.2.1.1
89
Cost Nexthop
3 10.2.1.1
7 10.2.1.1
AdvRouter
10.2.1.1
10.2.1.1
10.4.1.1
10.2.1.1
RtType
ABR
ASBR
Area
0.0.0.1
0.0.0.1
0.0.0.1
0.0.0.1